Lay the large flat surface on the print bed.

Requires two M3 bolts of any length, which goes through the pre-existing inserts on the sprite BL-touch mount.

Designed for 2x M3 bolts and nuts to attach the probe to the board, but you could easily use self tapping screws if thats what you have on hand.

Can also use an additional pair of M3 nuts between the probe and the adapter to give space for solder joints on back of the board and avoid crooked look. Not necessary at all.

Has a small hole for cable management, the connectors will push through if youre forceful, but is designed to have the sprite probe connector and ir z probe wires be spliced after the wires are fed through essentially locking the connectors in place preventing pullouts or getting stuck in models.

Physically works and mounted fine. Electrically BE WARNED. To my knowledge Creality have made Red as Ground and Black as Positive (found out with magic smoke escaping my board). Paypal is linked if you wanted to donate a small amount to go towards a replacement probe ahahah