Search models, users, collections, and posts
Union Force Toe Strap Insert
IP Report
Print Profile(1)
0.16mm layer, 3 walls, 15% infill
Designer
33 min
1 plate
Open in Bambu Studio
Boost
6
26
1
2
22
12
Released
Description
Designed to prevent the toe strap on the Union Force bindings from adjusting itself. Reduced a bit of the range of rotation on the strap, but shouldn't prevent you from strapping in at the angle you want. I printed mine in PETG but maybe ASA is more ideal since it'll be in snow. Only tested with the Union Force 2023 bindings, please drop a comment if you try it on other models.
To Install:
- Take bindings off board
- Slide the insert from the bottom up into the slot you want to block off
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)