Iphone 13 case hexagon magsafe ring - ergonomy by 3D

3D | KOCHEL

Hobby & DIY>Electronics

Print Profile(1)

All

0.2mm layer, 2 walls, 15% infill

Designer

51 min

1 plate

3.7(3)

Boost

Released

Description

Hi guys,

i found quite a few iphone cases stl-s out there, BUT every single one of them has (at least for me) one big issue.

All that cases has no chopout around the buttons, so if i hold the phone, this part of the case stays in the way for my fingers.

So i design my own cases where i mad it more fit into hand :)

You can clearly see, the buttons from the back, so when you hold your phone in hand, it rly helps with ergonomy. :) I hope you will like it :) I will make more designs so check my collection for one you will like most. :)

Also i added place for magsafe ring. So you can insert the magsafe ring and than your apple wallet will hang on the case like on original cases. :) diameter of extruded ring place is 43mm(inside) 57mm (outside) most of the rings i find on aliexpres / temu are around 45-50mm.

Comment & Rating (5)

@user88

Print Profile

0.2mm layer, 2 walls, 15% infill

I appreciate the work of the designer, but unfortunately the case does not fit properly on the phone, even the cutout around the camera island isn't perfect too. Otherwise, the design and construction are fine, but due to size inaccuracy, I can't give it 5 stars.

(Edited)

The designer has replied

@user_3024306727

thank you :) yeah it is taller for about 0,3mm it may feel like it is going to fall out but it cant :) i using 3 of this cases in different colors for more than month :) but thanks for the response, i will think about it, maybe next case i will do little tighter :)