Minimalistic Card-sized SD Card Holder by Whadup

Whadup

Tools>Organizers

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

[MiniFriendly, Plain Version]: 0.2mm layer, 5 walls, 20% infill

42 min

1 plate

5.0(8)

Boost

181

102

Released

Description

Suggested print settings for the Main Body:

Layer height 0.2mm.
Infill 20%.
Perimeters: 5 (for strength and aesthetic).
No supports are needed.

Suggested print settings for Micro SD attachment:

Layer height 0.2mm.
Infill 15%.
Brim: Width 2mm.
Brim Separation Gap: 0.2mm.
No supports are needed but follow the suggested print orientation for ideal results.

Suggested print settings for Cover - Ace of Spade:

Layer height 0.2mm.
Infill 20%.
Perimeters: 5 (for strength and aesthetic).
No supports are needed.

NOTE
Most of our designs are printed and tested on a Prusa Mini and MK4, so tolerances may vary if you are using a different brand. While we strive for a smooth experience with our designs, we appreciate your understanding if tolerance issues arise.

Changelog

19 Oct 2023: New cover design - Ace of Spade.
12 Oct 2023: Introduced an attachment that converts one of the SD card slots into a holder for 4 Micro SD cards.

Comment & Rating (11)

@MacsP1S

Print Profile

[MiniFriendly, Plain Version]: 0.2mm layer, 5 walls, 20% infill

fits all cards perfectly. love that it clips to secure, great little card carrier.

(Edited)

@PapaFigos

Print Profile

[MiniFriendly, Plain Version]: 0.2mm layer, 5 walls, 20% infill

Great design. thank you

@TomdeGroot

Print Profile

[MiniFriendly, Plain Version]: 0.2mm layer, 5 walls, 20% infill

very good

@davidcamick

Print Profile

[MiniFriendly, Plain Version]: 0.2mm layer, 5 walls, 20% infill

really high quality and I use it almost every day now. fits really easily into my pocket when I’m shooting.

@user_196390156

sd cards dont fit on p series. cool design though thank you.

(Edited)

@jared.michael.w

Print Profile

0.24mm layer, 2 walls, 15% infill

This is poorly sliced. Don’t try to print it without pulling it up in bamboo Lizer first for some reason it is trying to do the entire thing with bridging instead of the obvious and natural way to print the base first. Also it says it’s a complete print, but it’s not.