One of the complaints people have about the Audio Technica AD1000X, AD900X, and others is that the wings don't apply enough down pressure, and the headphones sit too far down on your head.

This is because the default angle of the 3D wings is too high.

This is a replacement for part of the internal hinge, which enables you to change the default angle, so the wings sit lower down and lift the headphones up more.

The angle can be adjusted by changing the Z rotation of the tabs in the slicer.

If you set the angle to 45º, it will match the stock ones.

If you set to 0º, the angle will be 45º lower than the stock ones.

Printed in PETG with a 0.2mm nozzle, with the bottom part with the tabs using 0.12mm layer height, and the top using 0.06mm layer height.

I haven't tried printing this with a 0.4mm nozzle, because this is a small part that needs precision.

These work on my AD1000X headphones, I haven't tested them with other model headphones, but they should work with similar models such as AD900X, AD700X.