Autodarts camera mount
Copyright Claim
Autodarts camera mount
Boost
14
9
11
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
2 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
3.4 h
1 plate
Open in Bambu Studio
Boost
14
9
11
3
16
12
Released
Description
A simple camera mount for OV9732 cameras for an autodarts setup only compatible with https://makerworld.com/en/models/209746#profileId-229695.
To install the camera mounts to the LED ringlight you do not need any screws, tools or other hardware.
The cameras can be installed with screws but you can also just glue them in place inside the mount. Thats up to you.
Simply snap all the parts together and run the camera cable through the mount. The whole mount itself, snaps onto the LED ringlight and holds itself in place easily. This way you can detach the mounts from the ringlight when you do not use them without effort.
The attached print profiles print each part you need three times, to get a complete set
I hope you like it
Comment & Rating (11)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
had to tweak a bit to make it fit my 3d printed light. the arms profile wouldn't print right, everytime it would fall over, even with supports added, end3d up laying them flat and printing one by one.
the arms stick out a lot further than other designs, so going to try a few diffrent models.
overall works well
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very nice work, works very great. would be nice to get the option to print the Parts in single version for spare parts.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld