Resin-Filter Holder
Remixed by
Copyright Claim
Resin-Filter Holder
Remixed by
Boost
5
5
3
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
6.6 h
3 plates
Open in Bambu Studio
Boost
5
5
3
0
11
4
Released
Description
My design now uses a steelpipe with outer diameter 22,5 mm (other diameters are possible). Other than that, only some M6 screws, washers and nuts are needed.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 3 walls, 10% infill
good Plane
0
Reply
perfect
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
(Edited)
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld