Bambu Dessicant Drier by Ook Laboo

Ook Laboo

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

6.8 h

2 plates

Open in Bambu Studio

Boost

Released

Description

This desiccant aka silica gel drier is designed to be used inside your Bambu X1C or alternatively, a Sunlu or similar filament drier.

The accompanying funnel has a slight oval shape to facilitate pouring the dried desiccant into a storage container or back into your AMS filament drying containers.

The hygrometer allows you to monitor the drying process to ensure that you have sufficiently dried your filament. After going through a heating cycle, wait until the container has cooled to room temperature before reading the humidity level of the container. It may take more than one cycle to sufficiently dry the gel.

The hygrometer is purchased from Niceco from Amazon: https://www.amazon.ca/gp/product/B07TKHCB5N/ref=ppx_yo_dt_b_search_asin_image?ie=UTF8&psc=1

Note: Not all desiccants are not made to be recycled through being dried.

dessicant conditioner

dry silica gel

dry dessicant

Comment & Rating (4)

@user_567631895

can you check the link for the hygrometer? what is posted appears to indicate that this product is not available. thanks.

The designer has replied

@user_3154573340

I just tested the link and it works. You may not be selecting the whole URL.

@starbase3d

This looks huge. I can't picture where this would fit in an X1C. Adding a couple photos of it in use, installed in your printer would go a long way to this list.

(Edited)

The designer has replied

@user_3154573340

You don't use it when printing! It's for holding silica gel while drying out the silica gel after it has absorbed too much moisture. You can use it in a filament drier or if you don't have a filament drier, use it on the bed of the X1C in the filament drying mode.

No more