5/8" Mic Stand
5/8" Mic Stand
Print Profile(1)
Description
This is my Mic Stand that I am currently using.
Uses a 5/8" mount. The printed threads for the pole can be temperamental, remember its plastic. Be careful screwing the mount onto the threads. Get it started straight and start twisting, it will be tight.
It can be extended an infinite amount, just print more extensions and more base nuts!
Extensions are not needed so if you need something short, print one base nut and no extension.
No brim, 100% infill on the ring and the mic pole mount (trust me on the pole mount)
1mm layer height on the base nut (you may have 1-3 strands of filament that wont connect, this is unintentionally normal, just pull them off and it'll be fine.
Requires 4 m3 heat inserts and m3 screws for the shoe. Can be printed and used without the shoe.
Comment & Rating (3)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
