Created this zombie to further test second colour and made the eyes green.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
- PLA BambuLab Basic Black
- PLA BambuLab Basic Blue
- PLA BambuLab Basic Gray
- PLA BambuLab Basic Jade White
- PLA BambuLab Basic BambuLab Green
- PLA Ziro Lime Green
Swap Instructions:
Start with Black
- At layer #7 (0.64mm) swap to Blue Gray
- At layer #14 (1.2mm) swap to Gray
- At layer #22 (1.84mm) swap to Jade White
- At layer #27 (2.24mm) swap to BambuLab Green
- At layer #30 (2.48mm) swap to Lime Green for the rest.
Enjoy my work? Support me by joining my club on printables. Tier 1 offers exclusive models, while Tier 2 allows you to sell my 3D printed artwork.