FPV Drone Stand (V3 now added)
Copyright Claim
FPV Drone Stand (V3 now added)
Boost
11
15
5
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
3.3 h
1 plate
Open in Bambu Studio
Boost
11
15
5
0
31
13
Released
Description
Here is my FPV Drone Stand, It holds my 5-inch, but I have tried to design it to hold different frames, some will fit nicer than others, V3 has a wider plate which should help prevent the rear of the quad from slipping off the side,
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 10% infill
Perfect Print. A “PP,” if you will. I slowed it down and jacked up the infill to like 50+% just for a nicer finish and a little more heft. Worked great. Polymaker PolyLite PLA Pro metallic gold. Quad in the last picture is a SpeedyBee Master 5 V2.
The designer has replied
0
Reply
looks fantastic, and thankyou for sharing your adjustments
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
good profile
The designer has replied
0
Reply
thankyou for rating and sharing
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld