Wide Mouth Ball Jar Candy Dispenser by toolmantim313

toolmantim313

Household>Other House Models

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 3 walls, 25% infill

Designer

21.9 h

4 plates

5.0(2)

Open in Bambu Studio

Boost

127

136

Released

Description

This is an awsome unit. I designed it to utilize a large mouth ball jar for the top container and two 608 bearings for the rotating arbor dispenser. The regular arbor dispenser sends out about 10 MnM's which is perfect. But I included a large and XL size as well. You will also need seven M4 x 10 SHCS and one M3 x10 with and type of head. The base, faceplate, and retaining washer use the M4's and the bowtie handle use the M3. I made it with the m3 just to not have a huge bolt on the handle. And technically the retaining bolt isn't even necessary since everything is “pinched” between the faceplate and main body.

I also printed the faceplate face down to use a “textured” style plate. (The one with all the colored circles). But you don't need to print it that way. But either way will need supports.

candy

dispencer

candydispenser

Comment & Rating (9)

@user_3570066785

Boosted

English description after the German. Hat sehr schön funktioniert 🍀 Ist wie auf dem Bild mit einem Unterschied: Der Drehhebel ich habe Bambu PLA mate verwendet, bei dem der automatisches Support absolut hervorragend herausbrach, sogar am Gewinde. Für die Schrauben habe ich andere verwendet, das ging auch. Man könnte das kleine Teil an der Walze auch dreimal drucken, damit man beim umtauschen der Walzen dies nicht abschrauben muss. Es sind drei verschiedene Walzen mit verschieden grossen Öffnungen für die Menge bei einem Dreh dabei. Beim Drucken dachte ich, dass der Fuss nicht so unheimlich stabil sein müsste. Allerdings kann man alle Mason Jar Gläser mit ,wide mouth‘ drauf schrauben, d.h. auch wirklich grosse mit viel Inhalt. Dann ist es super dass der Fuss schwer gestaltet ist. das ist ein Druck für Kindheits Erinnerungen ⭐️⭐️⭐️⭐️⭐️ Worked really well 🍀 It's like the picture with one difference: the handle I used Bambu PLA Mate and the automatic support came out absolutely brilliantly, even on the thread. I used different screws and that worked too. You could also print the small part on the roller three times so that you don't have to unscrew it when you swap rollers. There are three different rollers with openings of different sizes for the amount of material in one rotation. During printing I thought that the base didn't have to be so incredibly stable. However, you can screw all Mason jars with a "wide mouth" onto it, i.e. even really big ones with a lot of content. Then it's great that the base is heavy. This is a print for childhood memories ⭐️⭐️⭐️⭐️⭐️

(Edited)