Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
23 min
1 plate
Open in Bambu Studio
Boost
9
23
1
0
4
1
Released
Description
This is a ring to hold minifigures. Once you print the model, glue in a 1X2 stud into the rectangular space of the ring. It may need to be scaled up an additional 5 percent to hold the 1X2 stud. It cannot be sized down anymore than that because it will not fit the 1X2 stud. Enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)