Search models, users, collections, and posts
Wolverine Light Box
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% Gyroid infill, Init
Designer
4.9 h
2 plates
Open in Bambu Studio
Boost
21
34
15
0
35
12
Released
Description
Here is my play on a Mini Wolverine Chibi Light Box. Below are links to the USB plug i used, as well as the lights!
In order to print in more than 4 colors, after slicing, go through the first few layers in preview, and make sure to write down the print order for the colors. I left black and yellow in 1 and 2, then alternated 3 and 4 for the other 4 colors. All you do is watch for a color to finish, then swap to the next color while its printing another color. Super simple!
As for wiring the lights, i used a simple 2 wire USB connector, soldered the two wires to the board, then used hot glue to hold everything in place. Any issues, feel free to drop a message!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (15)