Bambu Filament Measuring Stick
Copyright Claim
Bambu Filament Measuring Stick
Boost
16
24
12
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
23 min
1 plate
Boost
16
24
12
0
33
38
Released
Description
needed a quick way to determine how much filament is remaining on spool, used Bambu spool to make, however SUNLU is pretty close as well since the spools are very similar.
Comment & Rating (12)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
some of the numbers are a bit smudged, but works like advertised
0
Reply
what's the formula you used? was it this?
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Printed fine, the 1K number was not as clean as the other and the 4 in 400 was also a little smudged. Probably just a minor tweak or so to the seetings. Printed on a P1S.
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Good idea. Not 100%, but enough to check if there is enough filament for the next six hour print. Thanks!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Just what I needed.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Useful for spool with measurement ruler
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld