BentoBox v2.0 TPU Noise Isolator - for Bambu Lab
Copyright Claim
BentoBox v2.0 TPU Noise Isolator - for Bambu Lab
Boost
15
31
8
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
15
31
8
1
27
17
Released
Description
Even with good quality 4020 fans, my BentoBox v2.0 still vibrates quite a bit when turned on. This is especially disturbing when the noise is amplified throughout the panels of the P1S. This is the solution - a simple TPU sheet that fits snugly on the bottom case of the BentoBox, effectively eliminating most of the vibrations produced.
*V2 update: Extended the L-channel slot for 2024 printers. Default 3MF file updated to reflect this change.
Cheers,
-K
Comment & Rating (8)
All
Printed it, but there is a fitment issue for the P1S 2024 model. I need to cut a small portion out in the L slot.
The designer has replied
0
Reply
Hi there, thank you so much for the feedback. I've extended the L slot for the 2024 printers - my P1S is a 2023 model. Not too sure if there is any difference between the two but mine did fit the original model just fine, an interesting change if such.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The print came out great with Polymaker PolyFlex TPU95.
I only had to extend the longer portion of the L channel with some flush cutters as it didn‘t fit my P1S out of the box.
An M3x8 screw worked great for keeping the Bento Box in place with its new footing.
The designer has replied
0
Reply
Hi there, thank you so much for the feedback. I've taken note and extended the L-channel for future users of the design.
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld