These slide-/ clip-on feet increase the height of the standing dryer by 15 mm.
Designed for Leifheit standing dryer, should fit most models with blue plastic corner pieces as feet. Note, that they are not symmetrical, so there are two versions for the “left” and “right” side (other side).
Should prevent your favourite robot vacuum from trying to climb the foot of the standing dryer. Designed for Roborock S7 but should be valid for most models with bumpers around 20 mm height or similar.
How to assemble:
Clip on to the metal pipe on the bottom and then slide onto the existing plastic feet.
Print settings:
Filament: PLA / PETG
Layer height: 0.3 mm
Infill: 20%, cubic
Perimeters: 6
Support: not needed
Top/bottom fill pattern: monotonic
Top/bottom solid layers: 5
Remixing/Customization:
Fusion 360 files available for full customizability. (Other formats on demand)