The basket fits exactly into the Creality Space Pi filament dryer.
Simply dry your desiccant / silica gel at 70°C for a few hours, stir from time to time.
The holes/slots are 0.8mm wide.
You may want to use OndraM's Air Vent Gap Spacer to increase the drying time …
This model is quite difficult to print, but therefore you don't have to assemble parts.
It's mandatory to use a high temperature filament like ABS, ASA, PC or similar!
PETG and PLA will deform.
Take care of slow printing, especially the overhangs and bridges.
I used 100% part fan for the overhangs and bridges.
A large brim (!) will help to prevent warping.
100% concentric infill will give a bit more stability.
The wall generator “Arachne” has problems with the bridges, use “Classic” instead.
No supports needed.
ASA worked better for me than ABS, but I uploaded both print profiles.