Cooking pot lid handle with m5 nut Remixed by eds_3d_shop

Remixed by

eds_3d_shop

Household>Other House Models

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 3 walls, 25% infill

1 h

1 plate

5.0(1)

Boost

Released

Description

I saved the lid from the cooking pot today

I changed the handle (https://www.printables.com/de/model/55816-pot-lid-handle) and put an M5 nut in there. This is how you can tighten the screw properly

I have linked my changed model and original below (thanks to the designer of the original for f3d file!)

Don't forget to set m5 nut after 20mm print (Colorchange). You will need m4x30mm screw for this handle.

Better print it in ASA/ABS! 15% infill and 3 shells..

Ich habe heute der Deckel von dem Kochtopf gerettet

Ich habe den Griff ((https://www.printables.com/de/model/55816-pot-lid-handle) geändert und da eine M5 Mutter reingesetzt. So kann man die Schraube ordentlich einziehen

Mein geändertes Model und Original habe ich unten verlinkt (Danke an den Designer von Original-Modell für f3d file!)

Vergisst nicht eine m5 Mutter in ca. 20mm Höhe einzusetzen (Farbwechsel). Man wird noch ca 30mm lange m5 Schraube benötigt.

Man sollte das in ASA/ABS drucken mit 25% Infill und 3 Wände..

Happy printing! :-)

Comment & Rating (3)

@andrzej.l

The author improved the design, now the print is great!

(Edited)

The designer has replied

@eds_3d_shop

Hello andrej.I, thank you for you message! Most of makes (many on printables) was print with ASA, which shrinks. And yea - the nut had a play in there but no issues. How i see on your pictures - you printing it in PETG? It shrinks not so much like ASA, maybe it was a problem.. But, I updated the version - it now fits better for m5 nut if you print it with PETG (shrinking is not so big like with ASA). The earlier version probably had too much play for PETG prints. Now it should fit very well for ASA/PETG. Thank you for your message and downloading! :-) Ed

(Edited)