I needed a couple of M6 slot nuts to attach the 40mm cable protection tube to the 38/40mm rail bracket.. I quickly started #Fusion360 and designed two variants.. I printed them in ASA so that they don't go limp in outdoor use ;-)
You can then take the M6 hex screws for this and glue them in (if required).
Ich habe für die Befestigung von 40mm Kabelschutzrohr an Schienenkonsole 38/40mm ein paar M6 Nutensteine gebraucht.. Mal schnell #Fusion360 gestartet und zwei Varianten entworfen.. Gedruckt habe ich sie in ASA, damit sie im Außeneinsatz nicht schlapp machen ;-)
Sie können dann die Sechkant M6-Schrauben dafür nehmen und (nach Bedarf) einkleben.
Printsettings: 3 walls, 55% infill, 5 layer top/bottom