This is my multipurpose Star Citizen themed container with a hinged lid! Its baded on the 8 SCU container from the video game!
Very easy print!

The model consists of: 2 parts, container and lid

Tools needed: none

Additional parts needed: a little strip of filament for the hinge

Assembly instructions:

Place the lid on the container and insert some of the filament into the holes provided. The holes in the lid are slightly smaller than the filament (at least when I printed it) so it might require some pushing (or drilling) to get it working.

Recommended filament: PLA, colorize the container and the lid as you wish and play with the colors!

Hotend: 0,40mm

Print time: 1h 26min

Assembly time: 1 minute

Print instructions:

layer height 0,20mm
2 wall loops
top/bottom shells 4 layers
top/bottom shell thickness 0,80mm
sparse infill 10%
sparse infill pattern “grid”
Before printing:

Make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For a good build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.

Bad build plate adhesion is not related to the model.

Please check out my other models https://makerworld.com/en/@BigEnnn and leave me a like and a decent rating if you were satisfied. Thank you in advance!