"Let me explain something to you, there is only one thing that matters if you are a shinobi, and it isn't the number of jutsu you possess. All you do need, is the guts to never give up."

This is my first public hueforge. I'm still learning the ways but wanted to share my favorite Naruto character from the series. The Pervy Sage will live on!!

The hueforge settings are below but I ended up tweaking it a bit in my slicer:
My Settings:
Swap Instructions:
Start with Black
At layer #8 swap to Jade White
At layer #13 swap to Black *
At layer #17 swap to Red
At layer #23 swap to Beige for the rest. *

------------------------------------------------------------------------------------------------------------------

Hueforge Settings

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Beige Transmission Distance: 8

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Jade White
At layer #16 (1.36mm) swap to Black
At layer #17 (1.44mm) swap to Red
At layer #20 (1.68mm) swap to Beige for the rest.