PhotonS Low Profile Venting Base
PhotonS Low Profile Venting Base
Print Profile(0)
No Print Profile yet. Add one to earn points.
Description
Summary
This is a remix of the otherwise AWESOME Anycubic Photon & PhotonS De-Stinky-Nator (aka Airfilter) by IdefixRC. I already have a ventilation system installed for my airbrush spray booth, so I decided to mod the base to accept a 55x110 rectangular conduit (later decided to go for 100 round flex, so I made an adapter) and added adjustable feet.
The top of the base has a shallow groove for a seal, in which I glued some bicycle vent hose (not sure if that is the correct term in English) which is basically 3.5mm round soft silicone hose. If you can't find that, a raised bead of silicone caulk would do as well. Just make sure the bead hardens before you put the printer on top. This should form a pretty good seal between the base and the printer.
The leveling...
When the base was done to my liking I put the printer on top and installed the resin vat. Then filled the resin vat just to the height of the inner bevel with water with a tiny drop of washing up liquid soap added to break the surface tension. Then levelled the printer -vat- by adjusting the screwlegs until I was satisfied.
HAPPY SUCKING!
Print Settings
Printer:
FLSUN QQ-S
Rafts:
Yes
Supports:
Yes
Resolution:
0.2 for the base, 0.1 for the legs and threaded inserts, 0.2 for the conduit adapters
Infill:
15% for the base, 75% for the legs and inserts
Filament: Generic PLA (tho PETG would have been better for UV resistance. Comment & Rating (0)
License
