Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
17
64
8
2
231
113
Released
Description
Simple screwable easter egg. Perfect for small objects to hide for the easter season.
The inside is hollow with a minimum diameter of about 3 cm / 1,18 in at the center. In the top and bottom half the diameter gets a bit bigger after the thread. The first screws are a bit stiff but after a few times it should open and close smoothly.
Size:
- Height: about 7 cm / 2,75 in
- Width: about 5 cm / 1,97 in
Material: I printed this in PLA and it worked perfectly fine, other materials should work as well but are not tested so far
Support: Yes, you can customize the support structure if you want however I found the default support to be working just fine.
Printer Settings:
- Layer Hight: 0,2 mm
- Layer Width: 0,4 mm
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)