Kitchen Tape Dispenser for 2in/50mm Rolls Remixed by milespaxton.mn

Remixed by

milespaxton.mn

Household>Office

Print Profile(0)

Add the first print profile to earn points

Boost

Released

Description

Quick remix to fit 2in (or 50mm) rolls of painters tape.

The sharpie holding loop in the final layers of the print is tricky. Considering printing with support or adjusting the print speeds there. As you can see in the pictures, mine failed at that point.

It needs to be well secured to the wall surface so you can rip the tape against the ‘blades’. Double-sided tape works well.

Comment & Rating (1)

@SoftPandaCubz

Nice remix! so I think the problem with the sharpie holder might actually be a problem with however you modified the model. the 3D preview and the downloaded slt file seem to be showing a weird gap on the left side of the sharpie holder. when you slice and go to that layer it’s easiest to see. at layer 577 the right side starts building but the left side does not. it isn’t until later 585 for the left side to start. I’m not sure why that’s happening but I would bet that’s why the sharpie holder part isn’t working out.

(Edited)