Face for Easter bunny egg from Petra Ollender
Remixed by
Copyright Claim
Face for Easter bunny egg from Petra Ollender
Remixed by
Boost
2
6
1
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
8.7 h
2 plates
Open in Bambu Studio
Boost
2
6
1
0
10
1
Released
Description
i created some faces for trhe easterbunny eggs from Petra Ollender
can be pressed and glued in
the STL has the 80% for the kinder surprise size
Comment & Rating (1)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Came out well. I didn't end up using it because the 'face' and my 'bunny eggs' were different scales - Oops! That was my fault. But the model and profile made for a good print. Now I just need to reprint the 'egg' at the same scale and I'll be all set for next Easter :-)
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld