This is a well designed model that prints with pre-set manual tree supports. I found that the print failed 4 times before it worked although I beleive this was possibly due to the new glowing green filament I was using over the normal Bambu Labs filament. I was unable to get the printer to successfully print more than one at a time, four attempts with slightly tweaked settings resulted in one of the two always failing. Again I believe this is more down to my filament than the stl provided although I will test with my traditional Bambu filament and respond back. What I can say is that the successful print looked amazing my only suggestion would be that if you want a glowing creeper as well increase the infill by around 10% as parts of the figure are translucent which diminishes the look.
Summary:
Printer: X1C
AMS: Single filament only
Filament: PLA Green glow in dark 1.75mm
Brand: Giantarm
Print Attempts: 5
Speed: Standard
Changes: None
Supports: Yes
Supports Type: Tree
Supports Ease of Removal: Very Easy
Recommendation: Yes