ESun Ebox or Sunlu S2 support for ikea SKÅDIS
Copyright Claim
ESun Ebox or Sunlu S2 support for ikea SKÅDIS
Boost
37
73
9
Print Profile(2)
For printing in parts, saving material and time
Designer
5.4 h
2 plates
0.4mm nozzle 0.24mm layer, 2 walls, 15% infill Tree Support
Designer
6.5 h
1 plate
Open in Bambu Studio
Boost
37
73
9
0
115
34
Released
Description
ESun Ebox support for ikea SKADIS board
Comment & Rating (9)
All
Print Profile
For printing in parts, saving material and time
Thanks for sharing and providing the separation parts. In case someone asks, my dryer is not the same as the designer and hence it is sticking put a bit from thr self but it does not bother me as long as it does work well.
The designer has replied
0
Reply
Hi ! Thanks for the message , if you are welcome the measurements of the dryer , I upload I make a modification and upload it so you can print only the top part , using the same base.
0
Reply
@salahunreal
https://makerworld.com/en/models/131474#profileId-142632
I have made a base for your dryer, I have uploaded a new model in which you only have to print the base, the legs are valid from the other design.
as I do not have that dryer you could put photos of how it looks and upload them to the profile.
Thank you very much
(Edited)1
Reply
Print Profile
For printing in parts, saving material and time
printed good and went together well. used some glue as well just in case.
0
Reply
Print Profile
0.4mm nozzle 0.24mm layer, 2 walls, 15% infill Tree Support
nice and helpful
0
Reply
Nice Design. I would like to give a suggestion to reduce the support. If you could separate the shelf itself from the hooks. So both could print separately would reduce materials and time.
The designer has replied
1
Reply
hello, it's a good idea, when I did it I was in a hurry and I didn't think about saving time and material, I just uploaded a profile for printing in parts, thanks for the advice.
0
Reply
Print Profile
For printing in parts, saving material and time
0
Reply
Print Profile
0.4mm nozzle 0.24mm layer, 2 walls, 15% infill Tree Support
0
Reply
No more
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Related Models
© 2024 MakerWorld