Skeleton hand iced coffee
Skeleton hand iced coffee
Boost
15
17
4
Print Profile(1)
0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill
Designer
4.8 h
1 plate
Open in Bambu Studio
Boost
15
17
4
0
9
5
Released
Description
colors can be adjust as the font and back ground are separate pieces.
must use a .2 nozzle to get the details in other wise it will miss a lot of the small lines.
its 1.25mm thick so it is thin but with a .2 nozzle still takes around 4.5-5hr.
Comment & Rating (4)
All
sorry to bother I just wanted to ask, I do not currently have a 0.2 nozzle but I was wondering if 0.4 would be acceptable without losing too much of the detail?
The designer has replied
0
Reply
i wanted to share this photo of me using a .4 nozzle. while its not bad overall you can see where there are missing details on the face and flowers. you can definitely try it out you will be able to see what will not print in the slicer before hand.
1
Reply
Print Profile
0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill
pretty decent
0
Reply
Print Profile
0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld