Raspberry Pi 5 Case (mod)

Here are some details related to this modification:
- the lower part was too tight, so it is slightly widened (0.3mm from inner side)
- gaps have been added on both pars for better ventilation and it takes less plastic to make
- print profile is configured to print slowly but the quality is better
- "mouse ears" were added to the top and bottom part to prevent warping (very easy to remove from the finished part)
- I decided to print the upper and lower part separately so that they don't stay on the table for a longer time (prevent warping)
 

Thanks to autor for original Raspberry case and happy 3D printing :)