Skadis WORX WX106 mount (T-Clip system)
Remixed by
Copyright Claim
Skadis WORX WX106 mount (T-Clip system)
Remixed by
Boost
6
3
0
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1 h
1 plate
Open in Bambu Studio
Boost
6
3
0
0
8
0
Released
Description
I found this useful model which helps to hold the WORX WX240/242 on the SKADIS board. That's very nice because I have one myself. But I also have a WX106 electric die grinder which is approximately 20mm longer than the former. so I built this remix. the model is extended a little in both directions to accommodate the WX106.
Accessories list:
- T-Clip / T-Clip mini x 2
- Magnet D10 x 1
Comment & Rating (0)
All
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld