Bunny drummer

About

Have fun with this rabbit drummer display. Turn the knob and the rabbit's paws will start to gently tap the egg-shaped drums.

Printing

The included print profile has options for single-color and two-color rabbit ears. Print only the parts you prefer.

Safety

Please exercise care around younger children as there are small parts.

Assembly

• Dry fit the parts before assembly.
  • If the fitting between any two parts is too tight, sand slightly.
  • Use glue if you want a more secure assembly, taking care not to affect any moving mechanism.

• Assemble the internal mechanism.
  • Rest the rabbit's (1) Body on its side, with the large hole facing up.
  • Remove the three small support pieces of the (2) Paddle.
  • Maneuver the (2) Paddle into place inside the rabbit (1) Body. Slot in the closed end first, with the hex-shaped hole facing up towards the large hole of the body.
  • Maneuver the (3) Washer to rest on top of the (2) Paddle, where the hex-shaped hole is (just inside of the large hole).
  • Insert the (4) Knob into the (2) Paddle to lock all three parts together.

• Assemble the paws
  1. Insert one of the (5) Paw Bone through the corresponding slot at the front of the rabbit. The flat side of the Paw Bone should face towards the bottom of the rabbit. The Paw Bone will face straight forward and not slant to the side when inserted at the correct slot.
  2. Fix the corresponding (6) Paw over the (5) Paw Bone. The flat side of the Paw Bone should face towards the bottom of the rabbit. The Paw will face straight forward, and not slant to the side when fixed at the correct side.
  3. Repeat for the other paw.

• Assemble the remaining parts
  1. Insert the two ears.
  2. Put the egg drums onto the base.
  3. Fix the rabbit onto the base.

Have fun and please check out my other models, TYSM!

___