Bambu Labs AMS Lifter bracket
Copyright Claim
Bambu Labs AMS Lifter bracket
Boost
16
35
3
Print Profile(1)
0.24mm layer, 4 walls, 15% infill
Designer
12.5 h
1 plate
Boost
16
35
3
0
22
6
Released
Description
Simple (but solid) brackets to allow AMS to be lifted. This allows the top glass of the printer to be easily removed but does not require that the cables or PTFE tube be lengthened.
Attached with 2 x M3 x 14mm screws with washers (see picture). For extra piece of mind, I have also used some heavy-duty double-sided tape on the sides of the printer.
I printed with PETG-CF for extra strength, as the AMS can be heavy. I would not recommend PLA.
Comment & Rating (3)
All
Can I use it to stack two AMS units on top? will the bottom one open as it should and will it be stable and secure?
The designer has replied
0
Reply
No, sorry. It does not lift it very much - just enough that the standard cable and PTFE tubes still reach.
0
Reply
Print Profile
0.24mm layer, 4 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld