Hello everyone! ✨

Yesterday I was looking for new inspiration for a model when I came across the Pokemon Archeus hold advertisement.

Then I realised! I'm going to do it! Searcing on the Internet I found a lot version and decide to make the mine.

Instructions:

My Pokeball is composed of three parts; a top, a bottom and a part that I called "joint".

This part is the most difficult to print. I made it using Bambulab filament as I recommend to use it. After printing this part let it cool down and try to bend it, if it doesn't bend you can force it with two pliers.

After checking that everything is good and working well, you need to place the "joint" inside the pokeball according to the figure.

Pay attention to the position of the joint! You can use a small drop of hot glue to hold it all together.

I hope everyone enjoys this and gives it ⭐⭐⭐⭐⭐!

My other design:

• Hueforge Pokemon
• Pokemon Model
• Design Model
• Hueforge