Skadis Zollstockhalter Querformat
Boost
21
64
13
Print Profile(4)
0.2mm layer, 2 walls, 10% infill
Designer
33 min
1 plate
0.2mm layer, 2 walls, 10% infill
42 min
1 plate
Strong Version - 100% infill
29 min
1 plate
0.2mm layer, 2 walls, 10% infill
46 min
1 plate
Open in Bambu Studio
Boost
21
64
13
3
83
77
Released
Description
Skadis Zollstockhalter im Querformat. So kann der Zollstock noch platzsparender untergebracht werden.
Öffnung 38 x 17,5mm
Für alle gängigen Gliedermaßstäbe
Comment & Rating (13)
All
Print Profile
0.2mm layer, 2 walls, 10% infill
👍
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Fits great with no issues
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
(Edited)
Strength Issue:The hook is already broken off when the support is removed. This is due to the low infill (third image). The hook is only held by the walls.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
passt perfekt
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Perfekt Danke
0
Reply
Print Profile
Strong Version - 100% infill
not a perfect fit for my ruler (mine is bit less wide. I would have helped being less of an issue of the side walls were higher. But I'm not complaining! It wasn't designed for my specific ruler. Thanks for sharing your design!
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
printed flawlessly, very good fit
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld