Slim Poop Chute Community Updated by minist3r

minist3r

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 5% infill

Designer

4.9 h

1 plate

4.8(15)

Open in Bambu Studio

Boost

124

Released

Description

I took my popular slim poop chute and adapted it using feedback from the community. This updated model has a removable bin, no magnets, thicker walls, less infill, and a higher backstop so the purge can't fall out the back.

Comment & Rating (21)

@MrDB42

Most excellent!! I have been searching off and on for a while now for a slim poop chute. None of my searches came up with anything I liked. I was on the verge of designing my own setup but decided to do one last search. Low and behold, this one came up as EXCATLY what I wanted and was going to design myself. You saved me a couple of hours of CAD work, thank you. Now I push my X1C back up against the wall and regain valuable table space in front of my printer. And it's easier to empty the waste now. Compared to the previous chute/bucket I printed (https://makerworld.com/en/models/15350?from=search#profileId-18691) EDIT: Added photo

(Edited)

The designer has replied

@minist3r

Thanks for the review. Would love to see the print too, if you don't mind.

@ARuncio27

your review helped secure this print for me 8 hrs to go

@bignozz

Boosted

Print Profile

0.2mm layer, 2 walls, 5% infill

Good print, it fits perfectly and it's super convenient. I suggest adding magnets on a new version so it stays in place, but so far it didn't move even without being attached. Thanks!

@enix1337

Print Profile

0.2mm layer, 2 walls, 5% infill

Great!

@AMR_3D

Boosted

Print Profile

0.2mm layer, 2 walls, 5% infill

Overall, the design is fantastic. However, the roof-like piece is a bit too steep to print cleanly without supports and was prone to sagging filament on the base print profile. Functionally though, everything still works as intended.

@Dude3D

Print Profile

0.2mm layer, 2 walls, 5% infill

Pictures might not be the best, but I love it and everything fits perfectly. Thank you!!

@user_3806372078

Print Profile

0.2mm layer, 2 walls, 5% infill

the top portion broke free in sports mode, glued it back together and interfered with the spool

(Edited)

The designer has replied

@ARuncio27

I go with silent on things I want to turn out nice

@minist3r

Replying to @ARuncio27 :

I do all my print profiles as if they are printed in standard mode because sport mode is so violent. I wish there was a way to set silent mode at print start though.

(Edited)