Pixel Fold Case by JoshCraft3D

JoshCraft3D

Tools>Gadgets

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1 h

1 plate

5.0(3)

Open in Bambu Studio

Boost

Released

Description

Simple Pixel Fold case. My fancy DBrand case started to fall apart, so I decided to design my own case for my Pixel Fold, as I had done with the Pixel 6 Pro. This is the result.

Included Fuzzy Skin blockers for those that want to texture the outer edge using fuzzy skin like I did.

Printed in PLA. Most likely will not work in TPU. I have no plans currently for a TPU variant, due to the complexity of the phones design. Would need adhesive attachment tape to keep it on if I were to try to do a TPU version. Not in to that really.

If you want Pattern like I did, turn off Top and Bottom Layers for the back, and up the infil percentage and set to honeycomb.

UPDATE:

06-28-24 : I don't talk on my phone much… Just realized I didn't make a Cut out for the Ear Speaker, haha. Updated the model to have it. Also edited the walls a bit, as I noticed a failure point due to wall thickness.

Added Case with Mag Safe Ring Cut, for Spigen MagFit ring that I am using.
https://www.spigen.com/products/magnet-ring-plate-magfit
Also added Base Step Files.

Comment & Rating (9)

@FreshAsTheD

Print Profile

0.2mm layer, 2 walls, 15% infill

Great print, highly recommended. I uses the stock profile with Bambu Silk Pla. The case has a perfect snap fit so you likely won't need any adhesive strips to keep the case plates on.

@tom.chan.0307

I am printing it out now. So far, the top is great! Fits well and no need for double sided tape to keep it in place. I do want to try the fuzzy side but I dont know what to do with the fuzzy blocker STLs. Can you please explain how to do it? Thanks!

The designer has replied

@JoshCraft3D

Right click on the part and do "Add Modifier". Select Load model and select the fuzzy skin blocker for the appropriate part. You then turn on Fuzzy skin for the whole print, but add a modifier for the fuzzy blocker to have Fuzzy skin set to None.

@JoshCraft3D

I have added a Print profile that hopefully will have it incorporated into it if you wanted to give that a look.

@NamesDcoy

how do you like it? my dbrand case also fell apart. they've already replaced it once and at this point I just want a refund and to try this bad boy out. I'll print it out tomorrow night. Thanks for making it!!

The designer has replied

@JoshCraft3D

It's been going great so far. It's also slimmer than the DBrand case. Only issue I have ran into is when standing it in "L" mode or whatever it's called, heh. It can be a bit more tippy because it is not as heavy on one side as it was with the DBrand Case.