Fidget Rings
Copyright Claim
Fidget Rings
Boost
3
8
2
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
2 h
1 plate
Open in Bambu Studio
Boost
3
8
2
0
17
12
Released
Description
Made this model because I had seen some before with thinner rings but the problem was that the rings came off! So I designed this so that the rings are a bit thicker as to not allow rings to come out easily. Battle tested by my students!
Ensure your surface is clean and has good adhesion! the rings are kind of thing but as long as your bed has good adhesion it should print fine!
Comment & Rating (2)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
really cool, spins awesome. I might see if there's some slicer settings to stagger the seam on the parts it's a little obvious when spinning it not on the model it's just the software limitations.
The designer has replied
0
Reply
Ah! yes that would be good! if you figure it out feel free to upload as another profile! thank you!
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld