I have problems with the support with the plate, 2 of the pieces had warping :/
did you use something for the plate? anyway probably I was too severe, I increase to 4, sorry
I didn't use anything on the plate (just made sure it was clean, printed perfectly (24 of them) without any warping, what material were you using (abs, pla, asa , petg?) , if you use any other materials than PLA you maybe need a bit of glue stick or another build plate if you have problems with prints sticking to the plate (or use a brim), but this is something for the user to do not a problem with the 3d model
very beautiful, I printed it with pla-cf for extra strength and a better surface to paint them. the detail is gorgeous at the layer height that is preselected. if you have the time I suggest going down to the next layer height below and it will be flawless!