A remix of my Overly complicated super glue TUBE holder for the AMS Stand, this time for the Gorilla Glue super glue bottles, as requested by Fuzz.

Prints in about 35 minutes and consumes about 20g of filament. The supports take an unfortunately large amount of filament and time (about 4g and 8min), but they are pretty much necessary due to the shape of the hole and the required print orientation (other orientations would lead to weak points in the “hook”-parts used to hang from the AMS drawer). I have also already manually tuned the supports to pretty much as small as I think is possible to get away with. I used SUNLU Matte PLA Back, but anything will probably do just as well. I chose that just because it's about the cheapest decent filament I've been able to get so far.

The print profile has two versions: “Option A” to be used with the standard sized drawers and “Option B” for the long drawers.
The plates 3 and 4 of the print profile have mirrored versions of the same models respectively, in case you want to place the super glue bottle holder to the opposite side of the AMS Stand.

The hole for the super glue bottle is 23.4x38mm, which is mainly intended for the 15g Gorilla Glue bottle available here where I live, but should also fit the smaller 12g. I'm not however sure about the possible other sizes available around the world…