Haunted Mansion wallpaper light box
Copyright Claim
Haunted Mansion wallpaper light box
Boost
25
33
7
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
7.2 h
2 plates
Open in Bambu Studio
Boost
25
33
7
1
11
8
Released
Description
All Bambu Lab Basic filaments, use the included profile and you will have a great experience.
Edit: for the shapes in the front shell and first 4 layers I used Polymaker Dark purple PLA , Bambu Labs purple, Bambu green.
9mm hole for adding an LED strip and the back plate has a 9mm ledge for adding cobb style led strips.
The ones I use are here. https://a.co/d/4MSEdrv
Comment & Rating (7)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
modified to make a 3-ring binder page separator
0
Reply
i had the same problem than you yesterday...
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Bed Adhesion Issue:Love the design! Print had some adhesion issues at the edges - my last lightbox came out perfect, but I am going to clean my bed and try again. However, one thing that can definitely be fixed in the profile is that the print overlaps the purge line so I also got a green stripe in the corner.
The designer has replied
0
Reply
clean that bed with hot water and dish soap then no touchy touchy, also, try repositioning the model and or pulling the purge line after the printer lays it down, otherwise almost had it! :D
0
Reply
Thank you for the feedback, but this was with a freshly cleaned bed. Can't the purge line just be removed from the profile or repositioned?
0
Reply
I want to try to do this with a pause on the eyes after the first layer. I'd do green on the first layer and glow in the dark for the layers after that.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld