Summary

So you printed the multiboard and need a cubical container?
Got your labelprinter? Calculator? Measure, customize and print it! Use snaps to attach it to the board.

There is also a cylinder version: https://www.thingiverse.com/thing:6527048

Like the design? Buy me a coffee ;)

Comment & Rating (1)

@jiri.mudrunka

Pegs are too small, I have scale the generated model it up by 3,1%, the spacing between pegs needs to be adjusted to compensate for scaling in advance - you need to use 24,25 mm instead of 25 mm, also the dimensions od the box might need adjusting. The original pegs are conical with 13,5 mm at it's base and 13,2 at a tip, scaling the model by 3,1% will make this peg around 13,4, which hold fine.

No more