AAA Mechanical Battery Dispenser by KG3Dee

KG3Dee

Household>Office

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

Main Parts - 0.2mm layer, 3 walls, 12% infill

Designer

4.7 h

1 plate

4.8(40)

Adjusting Parts - 0.16mm layer, 2 walls, 15% infill

Designer

1.1 h

1 plate

4.8(30)

A1 mini: 0.2mm layer, 2 walls, 15% infill

6.2 h

4 plates

5.0(1)

Open in Bambu Studio

Boost

138

244

337

240

Released

Description

This is a modified version of the AA Mechanical Battery Dispenser to hold AAA batteries.

Will store up to ~37 batteries.

Just as the AA version this print consists of two print profiles, one for 0.2mm layer height - and one for 0.16mm.

Both plates needs to be printed.

Main Parts, ~4h42m, 2 filament changes
Adjusting Parts, ~1h , 1 filament change

Shown model printed in Bambu PLA Basic Gold and Black.

For one color print set all colors to the same slot.

For assembly instructions, see: AA Mechanical Battery Dispenser

Comment & Rating (77)

@Ali_Kaa

Print Profile

Main Parts - 0.2mm layer, 3 walls, 12% infill

perfect!👍

@NomadSoul

Boosted

Print Profile

Main Parts - 0.2mm layer, 3 walls, 12% infill

I love this project

@awillkom

Print Profile

Main Parts - 0.2mm layer, 3 walls, 12% infill

Profile is excellent again. Tuning of the AAA batteries is even more fiddely than the AA model, took a lot of tries to get it "good enough" to not drop the batteries out. I'm still happy with the model though

@yabaigban

Print Profile

Adjusting Parts - 0.16mm layer, 2 walls, 15% infill

It wokrs perfectly.

@RichardSteinbac

Boosted

Print Profile

Adjusting Parts - 0.16mm layer, 2 walls, 15% infill

Again what a Great Design! The Screws to dial in the Distances are Special ! Kudoos on your Design Skills!

@the_shadow

Print Profile

Adjusting Parts - 0.16mm layer, 2 walls, 15% infill

Nice design, printed well.

@FilippoDP

Print Profile

Main Parts - 0.2mm layer, 3 walls, 12% infill

@Omnia

Print Profile

Main Parts - 0.2mm layer, 3 walls, 12% infill

@erwann.ke

Print Profile

Main Parts - 0.2mm layer, 3 walls, 12% infill

Strength Issue:great designe but all the screws broke when i just put them and without the guide and his screws the batterys fell down outside, i use a A1 mini with the default value of the model, i'm really disappointed.

@Clouded_Morpheu

Print Profile

Adjusting Parts - 0.16mm layer, 2 walls, 15% infill

Other Issues:had to sand the side rail down for 20 min in order for it let the batteries go in. if you load more than 8 betteries into the dispenser they mechanism jams. Then you have to push all the batteries up so you can force reset the push bar. In the photo you can see the bar stuck down.