Vacuum adapter with TPU hose for small spaces
Copyright Claim
Vacuum adapter with TPU hose for small spaces
Boost
1
8
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.5 h
2 plates
Open in Bambu Studio
Boost
1
8
2
0
6
2
Released
Description
Adapter to put on your vacuum cleaner to reach all those hard to reach places like the inside of a 3d printer or dry box.
I printed the Vacuum adapter itself in Sunlu PLA+ and the Vacuum TPU hose in Overture 95A TPU,
both upright with raft enabled.
The print profile is set to PLA for both plates. the small hose should be printed in TPU.
The Vacuum TPU hose is very long for such an upright print and if it gets a bit to wobbly at the end of the printing process,
then just stop the print and the hose will still be long enough.
The diameter of the adapter is 40mm so if your vacuum pipe is smaller or bigger you can upscale in Bambu studio,
Please don't forget to up/down scale both plates.
Comment & Rating (2)
All
Both print plates in the print profile say PLA, is it safe to use Tpu with this profile?
The designer has replied
0
Reply
The small tube should be TPU. But I run my Overture TPU external in a drybox. maybe that's why it didn't change it in the print profile.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld