Wanted to hang some of my spare 310x320 build plates on the side of my IKEA Alex so whipped up a quick solution that should fit plates in all sizes.

It can fit 3 plates (assuming they are less than 2 mm thick)

There are also included a upper and lower version that acts as a stop, in addition to the normal open one.

These are relatively quick to print, dont require supports if printed short end down.

These were made to use the screws I had, but I included step files in case you wanted to change it to your hardware or plates.

There are also versions with no holes if you want to use double sided tape or similar.