Lighting for Ender 3 V3 KE Toolhead
Adding Lighting to Creality Ender 3 v3 KE.
Components:
Instruction:
1. i jump a wire on the hotend fan seen on the image below so if the hot end heats ups the LED will also Turn On:
2. Create a voltage step down, please refer to the components resistor requirements based on you LED/ Strips voltage you have just of you have lower value resistors just connect them in series with the JST connectors and create a close circuit.
3. Skip this step if you have LED strips, Create a LED array on parallel connections see image below:
3. Connect the voltage step down to the wires shorted from the Board on one of the JST connectors and LED array to the Voltage step down we created seen on the image below:
Note: make sure your LED polarity is correct and connected it with the voltage stepdown in series else you can buy a variable voltage stepdown on your preferred market. recommended it print in PETG, ABS, or ASA