No Print Profile yet. Add one to earn points.
I needed an adapter for my Ender 5 to fit a Fysetc E4 board, so I created this quickly to do just that. You will need to cut a gap on the side so that you are able to reach microSD and USB, as I had already made this hole for my BTT 1.4 board, I didn't need to do anything, if you don't like the orientation you can always remix or turn it around and use extensions for USB and MicroSD.
I printed in PETG as it's what I had available to me in the Printer already.
The board holes are M3, and it uses the original screws from the Ender 5 original board.
Printer:
KingRoon KP3s
Rafts:
No
No
Resolution:
.28
15%
Filament: ERYONE PETG BLACK
Notes:
Make sure you scale it up for shrinkage, i did it 101% on Cura, so no adjustments needed after print.