Mailbox Flags (Outgoing and Incoming)
Mailbox Flags (Outgoing and Incoming)
Print Profile(1)
Description
Incoming and Outgoing Mailbox Flags
Recommendations
- Filament: PETG / ASA
- Button M3 Screws
- 15mm for use with adhesives
- 20mm for use with Heat Inserts / Nuts
- (Optional) Adhesive / Tape
- (Optional) M3 Heat Inserts
Printing
Base w/ Magnets & Flag w/ Magnets
The print profile is set to pause at layer 20 to allow the insertion of the 6x3 magnets. The magnets have been defined as a negative space on the parts.
Make sure the polarity is the same for all magnets. A trick is to stack the magnets and press the stack into the holes one by one.
Note: To ensure good layer adhesion, make sure to insert the magnet and resume the print as quickly as possible.
Base w/o Magnets & Flag w/o Magnets
The magnets have been omitted from the labeled parts.
Assembly
1Lay the base smooth side down. |  |
2Place the flag onto of the base by aligning the hole in the flag with the post on the base.
The handle should be placed facing upwards. |  |
3Place the top plate on the top of the assembly by aligning the center and corner holes with the hole on the center post and the base plate corner hole. |  |
4Insert two screws gently screwing them in until they are flush with the table / base.
Be careful not to over tighten. |  |
5Finally, align with mailbox and mark the screw holes on the mailbox.
Plastic Mailbox Installation Consider using an M3 heat insert to secure the M3 screws.
If you do not have M3 heat inserts, consider using shorter M3 screws and an adhesive tape.
Metal Mailbox Installation Drill a hole slightly smaller than the M3 screw and gently screw the screws in until they thread into the metal.
If you do not wish to drill a hole in the mailbox, consider using shorter M3 screws and adhesive tape. | |
Documentation (2)
Comment & Rating (0)
License
