"slide-out" Business Card Case US-Version Remixed by LemonArts

Remixed by

LemonArts

Household>Office

GIF

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

[US-Version] 0.2mm layer, 3 walls, 15% infill

Designer

3.1 h

1 plate

4.4(8)

Open in Bambu Studio

Boost

117

103

Released

Description

here is The US-Version of the “slide-out” business card case for 8 cards

load the spring with the cards, place these in the case and simply wipe the cards out

Comment & Rating (9)

@user_1845710858

Print Profile

[US-Version] 0.2mm layer, 3 walls, 15% infill

very good design. like it a lot

@scruffles

Print Profile

[US-Version] 0.2mm layer, 3 walls, 15% infill

Other Issues:one of the parts didn't print well, unfortunately. I'll try again with it flat on the bed

@MikX13

Print Profile

[US-Version] 0.2mm layer, 3 walls, 15% infill

It printed clean, but I couldn't get it to work. Perhaps it's just the type of business cards I have, but I could not for the life of me get them to slide out. Not sure if the spring is too tight, or I have too much friction in the cardstock of my cards, but I could not get this to work for me.

@Airitech

Print Profile

[US-Version] 0.2mm layer, 3 walls, 15% infill

Perfect size, easy print.

@MicB0t

nice but pointless. why make something that can only hold 4 cards.

(Edited)

@VSC42

Print Profile

[US-Version] 0.2mm layer, 3 walls, 15% infill

While easy to print, I was unable to make my business cards work with this case. In short sliding the card out of the case is next to impossible, potentially due to raised lettering on the card. Though I also tried another set of cards which were thicker and had a coating on the front surface likely causing drag.