Hi, I was a little bit bothered by that gap between the wall and the sensor when only using the magnet. That's why I designend it. It fits for both, the old and the new version. (the new one has a button on the back instead of a pin hole)
It uses the magnet the sensor comes with (use without the rubber).
Attached are 4 versions:
30/60 Degrees for a <7mm diameter screw head
30/60 Degrees for a <8mm diameter screw head
35/55 Degrees for a <7mm diameter screw head
35/55 Degrees for a <8mm diameter screw head
(The Angle depends on the orientation)
Prints without support!
I find it to look a bit cleaner that way. I hope you like it!
Happy printing! :)
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.